Can you tile an uneven floor

But in hindsight, we think that we should have started at one wall and worked our way to the other. The grout was in a bag that we had to mix ourselves but there were others that are premixed; however, they were more expensive. Your email address will not be published. This site uses Akismet to reduce spam. Learn how your comment data is processed. YouTube Freebies Newsletter. Start Here! Thresholds, such as a door step or floor barrier, may be necessary. Tip : use an extra litre of water where necessary.

The extra dilution will aid flow. As it spreads, use a trowel to paste the mixture around the whole space evenly, which will prevent subtle mounds from forming. Then leave the entire thing to dry for a couple of hours.

Does a section read as imbalanced? Rectify it with a second, very light coat of the mixing compound, then leave to dry again. However, if the self-levelling compound has dried, ensure you hoover and prime it before re-levelling. Now that the surface area is primed for installation, you can get to work on setting the tiles themselves. First off, scrawl two perfectly straight chalk lines from wall to wall.

This will break the subfloor up into quadrants. It almost goes without saying to use a long ruler for inscribing the chalk, so the lines are cohesive.

Second, lay the tiles out four at a time, attaching spacer tools cross-shaped pins that keep the tiling pieces separate between each of them. Tiles at the edges, however, are probably going to be too large for the parameters. The Rubi TRS Tile Cutter , for example, is able to slice through tile materials whilst providing a degree of shock absorption. Select a batch of adhesive — again, there are multiple variants suited for ceramics, porcelain, concrete, underfloor heating etc.

Once more, delineate every slab with a spacer: the plastic will not set on the adhesive, and you can remove them after the last tile has been sealed. Laying tile looks great, and is an excellent option for both indoor or outdoor spaces. When you lay tiles how flat does the ground need to be? As a general rule the floor needs to be almost perfectly flat.

Any less than that and the tiles become damaged very easily. You may wonder how flat the floor needs to be to set tiles on it, and the answer is — very flat. But, how do you go about installing some great looking tiles when the floor is uneven. As a whole you can install tile on an uneven floor, what you need to do first is apply a layer of levelling compound.

It will fill in any gaps, and go hard like concrete. You use a trowel to spread it out and make it flat and even. The reason it needs to be flat is so that the glue you use to stick to the tiles makes good contact. The more air holes and spaces underneath the tile the easier it is for them to break. When there are a lot of air bubbles on the underside of the tile they will crack even under normal conditions.

For uneven floors you can use a floating floor and have it sit in between the uneven surface and the desired flooring option you want installed. Any holes or divots in the underlying floor surface can be fixed with a filler compound.

With this in mind, I put together a list of the top 5 flooring options for when you have uneven floors and you are using a floating floor to accommodate the installation. Carpet is comfortable and is warm in winter. It helps keep the floors warm without needing underfloor heating. The texture of carpet also can mask minor imperfections in the underlying surface. Ideally, the underlying surface should be as flat as possible.

When you use carpet, however, the parts that are a bit uneven will be masked by the cushy top surface. There are three broad steps to installing carpet: preparing the surface, installing the smooth edge around the edges of the room, and installing the underfelt.

The smooth edges are pieces of thin wood with sharp spikes sticking up which grip the underside of the carpet.